Nice ERA TIME Instrucciones Y Advertencias De Instalación Y Uso página 8

• set the internal clock and date with Procedure 10 (N.B.: If you have run Procedure 1 after powering up the transmitter, only use Procedure 10 to change the basic settings).
6 - SETTING THE SPECIAL FUNCTION PARAMETERS
Caution! – When programming events, if you want to enable the "on vacation" and "planetary time" special functions, the parameters for these functions must already
have been set. To make these settings proceed as follows.
PROCEDURE 4 - Configuring the "ON VACATION" special function
Randomly moves the time of an event by a few minutes off its programmed time; this simulates the presence of an occupant when the house is unoccupied. If the "on vaca-
tion" special function has been applied to one or more events, you must also set the maximum offset relative to the programmed actuation time of the events in question. If
the function has not be applied to any programmed event, changing this value has no effect. To set the value, proceed as follows.
Step 1
main
screen
Auto
stop/esc
several times... (display)
Step 4 - end
(2)
(display)
NOTES:
(1) - The value can be set from 00
(*)
will actuate the event at any time between 7.45 (15 minutes before 8:00) and 8.15 (15 minutes after 8:00). The system will therefore start the event at any time in this
30 minute range.
(*) - Setting a value of 00 disables the function.
(2) - After Step 4, to return to the main screen, repeatedly press n/esc until Auto starts flashing.
7 – English
Step 2
Auto
sel
Man
Prog
2 times (display)
e.g.: 35 min.
ok
(35 + 35 = range 70 min.)
set confirm
(1)
to 75 minutes, in 5 minute steps. For example, if you set a value of 15 minutes and the event is programmed to start at 8.00, the system
Step 3
ok
Prog
 
confirm (display)
(display)
sel
2 times ON VACATION
ok
confirm