Startng/Stopping Instructions - McCulloch MB2500BP Manual De Usuario

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
6-1.STARTING A COLD ENGINE (Above 55˚F)
Mix the bottle of 2-cycle oil (included) with 1 gallon of unlead-
ed gasoline (less than 30 days old). Combine them in a sepa-
rate container using a 40:1 ratio. Pour into fuel tank.
1. Squeeze throttle (A) and push throttle lock (B) to
advance throttle for starting. (Figure 6-1A)
2. Pump "primer bulb" (C) 10 times. (Figure 6-1B)
3. Move choke lever to Choke "1".(Figure 6-1C)
4. With the unit on the ground, hold the top assist handle
and step on the bottom of the frame with foot. Pull
starter rope 6 times. (Figure 6-1D)
NOTE: The unit uses the Smooth Pull
which significantly reduces the effort required to start the
engine. You must pull the starter rope out far enough to
hear the engine attempt to start. There is no need to pull
the rope briskly--there is no harsh resistance when pulling.
Be aware that this starting method is vastly different from
(and much easier than) what you may be used to.
5. Move choke lever to "2" (Fig. 6-1E)
6. Pull starter rope again 1~6 times (Fig. 6-1F)
7. The engine should start. After 30 sec. Move choke to
"3".(Fig. 6-1G)
8. Squeeze throttle and release to disengage lock ; Unit
is now at idle. (Fig. 6-1A)
NOTE: If engine fails to start after repeated attempts,
refer to Troubleshooting section.
NOTE: Always pull starter rope straight out. Pulling starter
at an angle will cause rope to rub against the eyelet. This
friction will cause the rope to fray and wear more quickly.
Always hold starter handle when rope retracts. Never
allow rope to snap back from extended position. This
could cause rope to snag or fray and also damage the
starter assembly.
B
A
6 - STARTING/STOPPING INSTRUCTIONS
starting system,
TM
6-1A
C
6-1B
www.mymowerparts.com www.mymowerparts.com
D
6-1C
6-1D
6-1E
D
6-1F
6-1G
8