Returning For Service - DeFelsko PosiTector SHD Manual Del Usuario

Before returning the Gage for service...
1. Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
2. Examine the indentor tip and presser foot for dirt or damage.
3. Perform a Hard Reset
4. Attempt a measurement on the supplied test block.
(see Verification, pg. 3)
5. If issue is not resolved, Update your PosiTector gage body
pg.
( 9) and re-attempt measurements.
IMPORTANT:
If you must return the Gage for service, please fill out and include
the Service Form located at www.defelsko.com/support with the Gage.
Be sure to also include the probe, your company name, company
contact, telephone number and fax number or email address.
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth
on its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation. DeFelsko,
PosiTector and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and in
other countries. Other brand or product names are trademarks or registered trademarks of their
respective holders.
Every effort has been made to ensure that the information in this manual is accurate.
DeFelsko is not responsible for printing or clerical errors.

Returning for Service

. (pg. 5)
and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2016
All Rights Reserved
10