Environment Protection - Zanussi ZRG616CW Manual De Instrucciones

squashed or damaged power plug may overheat
and cause a fire.
3. Make sure that you can come to the mains plug
of the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do not insert
the power plug. There is a risk of electric shock
or fire.
6. You must not operate the appliance without the
5)
lamp cover of interior lighting.
• This appliance is heavy. Care should be taken when
moving it.
• Do not remove nor touch items from the freezer com-
partment if your hands are damp/wet, as this could
cause skin abrasions or frost/freezer burns.
• Avoid prolonged exposure of the appliance to direct
sunlight.
• Bulb lamps
6)
used in this appliance are special pur-
pose lamps selected for household appliances use
only. They are not suitable for household room illu-
mination.
Daily use
• Do not put hot pot on the plastic parts in the appliance.
• Do not store flammable gas and liquid in the appli-
ance, because they may explode.
• Appliance's manufacturers storage recommendations
should be strictly adhered to. Refer to relevant instruc-
tions.
Care and cleaning
• Before maintenance, switch off the appliance and dis-
connect the mains plug from the mains socket.
• Do not clean the appliance with metal objects.
• Regularly examine the drain in the refrigerator for de-
frosted water. If necessary, clean the drain. If the
drain is blocked, water will collect in the bottom of
the appliance.
Installation
Important! For electrical connection carefully follow the
instructions given in specific paragraphs.
5) If the lamp cover is foreseen
6) If the lamp is foreseen
7) If a water connection is foreseen
• Unpack the appliance and check if there are damages
on it. Do not connect the appliance if it is damaged.
Report possible damages immediately to the place
you bought it. In that case retain packing.
• It is advisable to wait at least four hours before con-
necting the appliance to allow the oil to flow back in
the compressor.
• Adequate air circulation should be around the appli-
ance, lacking this leads to overheating. To achieve
sufficient ventilation follow the instructions relevant
to installation.
• Wherever possible the back of the product should be
against a wall to avoid touching or catching warm
parts (compressor, condenser) to prevent possible
burn.
• The appliance must not be located close to radiators
or cookers.
• Make sure that the mains plug is accessible after the
installation of the appliance.
• Connect to potable water supply only.
Service
• Any electrical work required to do the servicing of
the appliance should be carried out by a qualified elec-
trician or competent person.
• This product must be serviced by an authorized Serv-
ice Centre, and only genuine spare parts must be used.

Environment Protection

This appliance does not contain gasses which
could damage the ozone layer, in either its refrig-
erant circuit or insulation materials. The appliance shall
not be discarded together with the urban refuse and rub-
bish. The insulation foam contains flammable gases:
the appliance shall be disposed according to the appli-
cable regulations to obtain from your local authorities.
Avoid damaging the cooling unit, especially at the rear
near the heat exchanger. The materials used on this ap-
pliance marked by the symbol
7)
are recyclable.
13