EINHELL TC-SM 2534 Dual Manual De Instrucciones Original página 39

•
Never wedge the hinged guard hood in open
position.
•
Never dismantle the machine's safety devices
or put them out of operation.
•
Damaged or faulty safety devices have to be
replaced immediately.
•
Never cut workpieces which are too small to
hold securely in your hand.
•
Do not place your hands in awkward positions
where one or both may slip suddenly and
touch the saw blade.
•
When working with long workpieces, use an
additional support (table, stand, etc.) to pre-
vent the machine from tipping over.
•
Always clamp round workpieces such as do-
wel rods etc. with suitable devices.
•
There must be no nails or other foreign bo-
dies in that part of the workpiece you want
to cut.
•
Always stand to the side of the saw blade
when working with the saw.
•
Never load the machine so much that it cuts
out.
•
Always press the workpiece firmly against
the table and the stop rail to prevent it from
wobbling or twisting.
•
Make sure that off-cuts can be removed from
the side of the saw blade. If not, they may
catch on the saw blade crown and be cata-
pulted into the surrounding area.
•
Never saw several workpieces simultane-
ously.
•
Never remove loose splinters, chips or jam-
med pieces of wood when the saw blade is
running.
•
To rectify faults or remove jammed pieces of
wood, always switch off the machine first. -
Pull out the power plug!
•
Conversions, adjustments, measurements
and cleaning jobs are to be performed only
when the motor is switched off. - Pull out the
power plug!
•
Before you switch on the machine, check that
all wrenches and adjustment tools have been
removed.
•
When you leave your workplace, switch off
the motor and pull out the power plug.
•
Electric installation work, repairs and
maintenance are to be carried out only by
specialists.
•
All guards and safety devices have to be
refitted immediately after completion of any
repairs or maintenance.
•
It is imperative to observe the manufacturer's
safety, operating and maintenance instruc-
Anl_TC_SM_2534_Dual_SPK8.indb 39 Anl_TC_SM_2534_Dual_SPK8.indb 39
GB
tions as well as the dimensions quoted in the
technical data.
•
It is imperative to observe the accident
prevention regulations in force in your
area as well as all other generally recognized
rules of safety.
•
Switch on the dust extraction system each
time you use the machine.
•
The machine may be used in closed rooms
only in conjunction with a suitable vacuum
extraction system.
•
Never use light-duty machines for heavy-duty
work.
•
Never use the cable for any purpose other
than that for which it is intended!
•
Adopt a firm standing position and keep your
balance at all times.
•
Check the tool for signs of damage!
•
Before you carry on using the tool it is impe-
rative to check that its safety devices and any
slightly damaged parts are working properly
and in the way intended.
•
Check that the moving parts work properly
and do not jam or whether any of the parts
are damaged. All parts must be fitted correct-
ly and satisfy all conditions for the tool to work
properly.
•
Unless otherwise stated in these instructions,
damaged safety devices and parts must be
repaired or replaced by experts in an appro-
ved specialist workshop.
•
Have damaged switches replaced by a custo-
mer service workshop.
•
This tool complies with the pertinent safety
regulations. Repairs are to be carried out
only by qualified electricians using original
replacement parts. The user may suffer an
accident if this condition is not observed.
•
If the table insert is worn, replace it.
•
Never use blades made of high-speed steel
(HSS).
- 39 -
15.03.16 12:07 15.03.16 12:07