Worx WX372 Manual De Instrucciones página 10

left). Only use reverse rotation marked "
(lever is moved to the right) to remove screws
or release a jammed drill bit.
waRNINg: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
4. TwO-SPEED gEaR CONTROL (See Fig.C)
The drill has a Two-Speed Gear Control (3)
designed for drilling or driving at LO (mark is
1) or HI (mark is 2) speeds. A slide switch is
located on top of the drill to select either LO
or HI speed. When using the drill in the LO
speed range, the speed will decrease and the
drill will have greater power and torque. When
using the drill in the HI speed range, the speed
will increase and the drill will have less power
and torque.
gear I
Low speed range: for screwdriving or working
with large drilling diameter.
gear II
High speed range: for working with small
drilling diameter.
10 waRNINg: To prevent gear damage,
always allow the chuck to come
to a complete stop before changing the
direction of rotation or the two-speed
gear train.
5. CHUCK aDjUSTMENT (See Fig.D)
To open the chuck jaws rotate the front section
of the chuck (1). Insert the drill bit between
the chuck jaws and rotate the front section in
the opposite direction. Ensure the drill bit is
in the center of the chuck jaws. Finally, firmly
rotate the front chuck section in the opposite
directions. Your drill bit is now clamped in the
chuck.
6. TORqUE aDjUSTMENT aND HaMMER
OR DRILLINg CONTROL (See Fig.E)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring (2). The torque is greater
when the torque adjustment ring is set on
a higher setting. The torque is less when
the torque adjustment ring is set on a lower
setting.
Lithium-Ion cordless hammer drill
" When drilling in masonry and concrete choose
the hammer position
When drilling in wood, metal, plastic and
screwdriver choose the drill position
Make the setting as follows:
1 - 4 for driving small screws
for driving screws into soft
5 - 9
material
for driving screws into soft and
10 - 14
hard material
15 - 19 for driving screws into hard wood
20 - 22 for driving larger screws
for heavy drilling
for drilling in Brickwork and
concrete
7. aUTOMaTIC SPINDLE LOCK
The automatic spindle lock allows you to
use as a regular screwdriver. You can give an
extra twist to firmly tighten a screw, loosen
a very tight screw or continue working
when the battery energy has expired. For
manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
8. SIgHT LIgHT
The Sight Light (8) allows you to keep a clear
view under less illuminated circumstances.
To turn on the light simply press the on/off
switch. When you release the on/off switch,
the light will go out.
9. DRILLINg
Drilling
Set the Torque adjustment ring to the "Drilling
without impact" symbol
deactivated in the "Drilling" position.
Impact Drilling
Set the Torque adjustment ring to the "Impact
drilling" symbol
position, the safety clutch is deactivated and
the maximum power is always effective.
Move the drill bit into the workpiece, applying
only enough pressure to keep the bit cutting.
Do not force or apply side pressure to
elongate a hole.
.
.
. The safety clutch is
. In the "Impact drilling"
EN