Honeywell HL10 Serie Manual Del Propietário página 7

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
FAN SPEED CONTROL
3 settings: High, Medium and Low.
TIMER CONTROL
The Timer is adjustable between 1 - 24 hours.
AUTO TURN OFF:
While unit is running, press the TIMER button and the display will flash. While the display is flashing,
press the + or - button to select the number of hours you want the unit to turn OFF automatically.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), press the TIMER button and the display
will flash. While the display is flashing, press the + or - button to select the number of hours until you
want the unit to turn ON automatically.
TEMPERATURE CONTROL
• Used for adjusting the timer and thermostat.
• The default display is room temperature.
• In cooling mode, when + or - button is pressed, the set temperature is displayed and may be
adjusted. After 5 seconds the display will revert back to room temperature.
Note: By pressing both + / - buttons at the same time, the display will toggle between Celsius and
Fahrenheit.
WATER FULL LIGHT
Condensation may accumulate in the unit. If the bottom internal tank is full, the WATER FULL light will
illuminate and an alarm will beep for 30 seconds. The unit will not operate until the water has been
drained from the bottom drain plug (refer to Water Condensation Drainage).
After switching the air conditioner off, the compressor will not start immediately. You must
wait about 4 minutes before it switches back on again.
EN 6