Saitek X-55 RHINO H.O.T.A.S. SYSTEM Manual Del Usuario página 21

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 114
1. Name of the Part being Modified
This will either be the Stick or the Throttle unit for the X-55. If you wish to change the part that you're not
currently on, use the back button (5) to go back to the selection screen.
2. Modifiable Axes
This shows a list of all modifiable axes. The Stick has three modifiable axes:
-
X Axis
-
Y Axis
-
Rudder Axis
The Throttle unit has six modifiable axes:
-
Left Throttle
-
Right Throttle
-
Rotary 1
-
Rotary 2
-
Rotary 3
-
Rotary 4
3. Manual Axis Adjustment and Test Area
This area will show you how the current response curves / dead zones / saturation points are set up on
the selected axis. You can also adjust the center deadzone, the range saturation, physical saturation, and
the response curve on the selected axis. There is also a cross-hair which will show the physical position
of the axis you are manipulating.
4. Spring Values
This is a reference section when you are adjusting the axes on the Stick. It will act as a guide for axis
modification, and you may choose differing axis curves or deadzones depending on the Spring you have
fitted to the Stick. If you are modifying the Throttle unit's axes you will not see this reference section.
5. Back Button
Takes you to the device selection screen.
6. Physical Axis Adjustment Slider
Allows the ends of the axes, the far left and far right on the X Axis or full up and full down on the Y
Axis, to be moved inwards towards the center point. It is similar to setting up a deadzone at the far ends
of your axes. on the Y-Axis to be moved inwards towards the center point, it is similar to setting up a
deadzone at the far ends of your axis.
20
Tabla de contenido
loading

Tabla de contenido