Engine Oil And Filter - HUSTLER Super S 938803CE Manual Del Operador

IMPORTANT: Do not overfill the fuel tanks. The fuel tanks
should be filled no higher than the bottom of the fill neck.
(Figure 4-6) The fuel system is designed to leave room for the
CZ
fuel to expand with fuel temperature changes.
Overfilling the fuel tank may cause the following:
• Engine damage
DA
• Fire hazard!
Fill to the bottom of the filler neck
DE
Maximum
Do Not
Overfill
EN
A. Filler neck
ES
Use regular unleaded gasoline with an octane rating of 87
or higher. Maximum of 10% ethanol (E10) in fuel. Fuels with
greater than 10% ethanol (such as E15, E20 and E85) voids
warranty. Fuels with greater than 10% ethanol are not
approved for use and such illegal use could cause equipment
FR
failure and pose a fire hazard.
Refer to the Engine Owner's Manual for additional fuel
specification requirements.
Fuel Shut-off Valve
This mower is equipped with a fuel shut-off valve. It is
IT
located under the right front of the control panel.
When closed the fuel shut-off valve prevents fuel flow to
the engine. Figure 4-7
Fuel Evaporation System Filter
NL
These mowers have a fuel evaporation system filter. This
filter must be checked and replaced every 500 hours or
annually whichever comes first. Figure 4-8
PT
SV
REV A
A
B
B. Fuel tank
Figure 4-6
A. Fuel shut-off valve
A
A. Fuel evaporation system filter

Engine Oil and Filter

Allow the engine to cool before changing the
engine oil. If the engine has been running, use
caution when changing the engine oil as it will be
very hot. You should wear the appropriate
protective gear to avoid being burned or exposed
to engine oil.
Check the engine oil daily and after every 4 hours of
operation. The mower must be level when checking the oil.
Refer to the Engine Owner's Manual and maintenance
schedule for oil recommendation and capacities. Hustler
Motor Oil is recommended.
Change the engine oil and filter after the first 5 hours of
operation and per
recommendations after that. Change the engine oil more
frequently if operating in extremely dirty conditions.
4-4
A
Figure 4-7
Figure 4-8
the engine manufacturer's
606834CE
®