Important Safety Instructions; Before Start-Up - Makita VC2010L Instrucciones De Uso

D
Makita VC2010L / VC2511 / VC3511L
GB

Important safety instructions

F
NL
I
Before using the vacuum cleaner, always read the operating instructions and keep them readily avail-
able.
N
Purpose and intended use
S
Besides the operating instructions and the binding accident prevention regulations valid in the country
of use, observe recognised regulations for safety and proper use.
DK
The appliance must
SF
– only be used by persons, who have been instructed in its correct usage and explicitly commis-
sioned with the task of operating it
– only be operated under supervision
E
– not be used by children
P
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
GR
The vacuum cleaners described in this operating manual are suitable for
TR
– sucking up dust and li quids
– commercial use, e.g. in hotels, schools, hospitals, factories, shops, offices and rental businesses.
SLO
VC2511:
This appliance is not suitable for picking up hazardous dust.
HR
VC2010L / VC3511L:
The appliances VC2010L and VC3511L are suitable for separation of dust with an exposure limit of
SK
greater than 1 mg/m³, (dust class L). Please observe regulations valid in your country.
CZ
PL
The following materials should not be picked up by the vacuum cleaner
– VC2511: hazardous dust
– hot materials (burning cigarettes, hot ash, etc.)
H
– flammable, explosive, aggressive liquids (e.g. petrol, solvents, acids, alkalis, etc.)
– flammable, explosive dust (e.g. magnesium dust, etc.)
RO
The appliance must
– only be used indoors and not outdoors
BG
– be protected against UV radiation
RUS

Before start-up

EST Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power
supply. It is recommended that the vacuum cleaner should be connected via a residual current circuit
breaker.
LV
Inspect power cord regularly to detect signs of damage, e.g. cracks or ageing. If the power cord is
LT
damaged, it must be replaced by Makita Service or an electrician to avoid danger before use of the
vacuum cleaner is continued. Use only the type of power cord specified in the operating manual. Never
use the vacuum cleaner if the filter is damaged.
VC2010L / VC3511L:
When dust removers are used, the rate at which air is exchanged in the room must be adequate if the
exhaust air from the vacuum cleaner is blown into the room (please observe regulations valid in your
country).
14