Husqvarna TC 250 2009 Manual De Uso página 98

MUM1-250_310_450_510_2009_GB
The standard calibrations and the adjustment procedures are
shown below.
ADJUSTING THE COMPRESSION FORK
a) EXTENSION (Lower register)
Standard calibration: -20 clicks.
Remove plug (B) and turn register (A) clockwise until the posi-
tion of fully closed is reached then, turn back by the men-
tioned clicks.To obtain a smoother braking action, turn the reg-
ister anticlockwise. Reverse the operation in order to obtain a
harder action.
a)
A
b)
C
32
18-11-2008 11:10 Pagina 32
b) COMPRESSION (upper register)
Standard calibration: - 20 clicks;
To reset standard calibration turn register (C) clockwise to
reach the position of fully closed; then, turn back by the men-
tioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
c) AIR VENT (to carry out after each competition, or monthly).
B
Place the vehicle on a central stand, pull the fork all out, then
remove the cap (E) and press the valve with a tip. Fit the cap
back in.
WARNING!
NEVER loosen the screw (F).
WARNING: Never force the adjusting screws
beyond the maximum opening and closure
positions.
E
F
C
C