Idiomas disponibles
Idiomas disponibles
The appearance of the lawn will improve if you alternate
cutting in both directions at the same height.
• For mulching: always avoid removing a large quantity
of grass. Never cut more than one third of the total grass
height in a single passage! Regulate the forward speed
according to the lawn conditions and the amount of
grass removed.
When finished mowing, release the lever (1) or both
levers (1a).
Disconnect the extension cable FIRST from the general
socket (2) THEN from the side of the lawnmower switch
(3).
WAIT UNTIL THE BLADE STOPS before making an ad-
justments to the lawnmower.
IMPORTANT - If the motor stops because it is overheated
while mowing, you must wait about 5 minutes before
restarting it.
IMPORTANT - Routine and accurate maintenance is
essential in maintaining original machine safety and
performance levels.
Store the lawnmower in a dry place.
1) Wear sturdy work gloves before cleaning, maintaining
or adjusting the machine.
2) Accurately wash the machine with water after cutting,
remove grass debris and mud accumulated in the
chassis to prevent it from drying and causing prob-
lems the next time the lawnmower is used.
3) Always make sure the air intakes are free of debris.
Each adjustment made to the blade is best if done
at a specialised Centre that has the most appropriate
tools.
Only blades with the following code must be used on this
machine:
81004157/0
Blades must always be marked «GGP». Given product
evolution, the above mentioned blades may be replaced
in time by others, with similar interchangeable and oper-
ating safety features.
Reassemble the blade (2) with the code and markings fac-
ing the ground, following the steps indicated in the illus-
tration.
Tighten the central screw (1) using a torque wrench set to
30 Nm.
Do not spray water onto and avoid wetting the mo-
tor and electrical components.
Do not use aggressive liquids to clean the chassis.
Remove dust and grass residue from the air intake
once a month, blowing compressed air onto the mesh.
Environmental protection should be a priority of consider-
able importance when using the machine, for the benefit
of both social coexistence and the environment in which
we live.
– Try not to cause any disturbance to the surrounding
area.
– Scrupulously comply with local regulations for the dis-
posal of waste materials after mowing.
– Scrupulously comply with local regulations for the dis-
posal of packaging, deteriorated parts or any elements
with a strong environmental impact; this waste must not
be disposed of as normal waste, it must be separated
and taken to specified waste disposal centres where the
material will be recycled.
– When decommissioning, do not pollute the environ-
ment with the machine, hand it over to a disposal cen-
tre, in accordance with the local regulations in force.
For any doubts or problems, please do not hesitate to
contact your nearest Customer Service Centre or Your
Dealer.
