Electrical Connection; Intended Use; Extension Cable - AGP SCS7 Instrucciones De Seguridad

carbon brushes could cause a fire or explosion.
16. There are certain applications for which this tool was designed. The manufacturer strongly
recommends that this tool NOT be modified and/or used for any application other than for which it was
designed. If you have any questions relative to its application DO NOT use the tool until you have written
the manufacturer and have been advised.
17. Only use the machine for cutting in stone, concrete or masonry.
18. Use the auxiliary handles supplied with the tool. Loss of control can cause personal injury.
19. Use a residual current device (PRCD) (not included) to protect from current surges.
20. Keep power supply cord clear from the working range of the machine. Always lead the cable away
behind you.
21. Immediately switch off the machine if unusual vibrations or if other malfunctions occur. Check the
machine in order to find out the cause.
22. Only use and store diamond blades according to the Manufacturer's instructions.
23. Pay attention to the dimensions of the blades. The diameter of the center bore must engage the arbor
without play. If not use any necessary reduction pieces or adapters (supplied with the blade) to ensure a
proper fit.
24. Take care to avoid hidden electric lines, gas and water pipes. Check your working area, e.g. with a
metal detector before commencing work.
25. The dust that arises when working with this tool can be harmful to health. Use a dust absorption
system and wear a suitable dust protection mask and remove deposited dust with a vacuum cleaner.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate. Under no circumstances
should the tool be used when the power supply cable is damaged. A damaged cable must be replaced
immediately by an authorized Customer Service Center. Do not try to repair the damaged cable yourself. The
use of damaged power cables can lead to an electric shock.

INTENDED USE

This saw is designed exclusively for wet or dry cutting of stone, concrete and masonry. This machine should not
be used for cutting other materials. The machine should not be converted or modified, e.g. for any other form
of use, other than as specified in these operating instructions. The user shall be liable for damages and
accidents due to incorrect use.

EXTENSION CABLE

If an extension cable is required, it must have a sufficient cross-section so as to prevent an excessive drop in
voltage or overheating. An excessive drop in voltage reduces the output and can lead to failure of the motor.
Never use two extension cables together. Instead, use one long one.
GB
6