Safety Devices; Electrical Connection - AGP CS11 Instrucciones De Seguridad

SAFETY DEVICES

1. Hand Guard: Protects the hand from debris and helps to block a broken chain. Never operate without the
hand guard in place. Replace if damaged.
2. Splash Flap: Protects from thrown debris and slurry. Never operate without the splash flap in place.
Replace if damaged.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate.
Under no circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
WARNING: This machine is equipped with a Portable Residual
Current Device (PRCD) also known as a Ground Fault Circuit
Interrupter (GFCI). Always use this device whenever using the
machine to reduce the risk of shock hazards. Test and reset the
PRCD device before each use. Press the "Test" button to test.
Press the "Reset" button to energize the circuit.
WARNING!: If 110V UK machines are not equipped with a PRCD portable residual current device or
GFCI ground fault circuit interrupter interrupter, the machine must always be used with an isolating
transformer for protection in case an electrical fault should occur. Use an RCD in a separate control box
with one or more socket outlets in accordance with EN 60309-2 with the earthing contact position 1 h.
Always use a residual current device with a tripping current of 30 mA or less.
INSTALLING THE GUIDE BAR AND CHAIN
1.
With the 2 side cover nuts removed and the side cover removed, slacken the tension adjustor by turning
anticlockwise.
2.
Slip the guide bar into position over the studs with the hole
engaged with the adjustor pin. (the bar is symmetrical and may
be installed with either side up)
3. Place the chain around the drive sprocket first, ensuring that
the drive links engage the sprocket teeth.
4.
Starting from the drive sprocket end, loop the chain around the
guide bar nose sprocket, ensuring that the drive links engage
with the guide bar groove and remain engaged with the sprockets.
5.
Place the side cover in position and thread on the 2 side cover nuts, leaving them finger tight only (to
allow the tension adjustor to be adjusted). They will be tightened fully after tensioning according to the
instructions below.
GB
Reset Button
7
On Lamp
Test Button
Guide Bar
Side Cover Nuts