Sharpening Dull Diamond Blades - AGP SCS7 Instrucciones De Seguridad

GB
Do not force the cut. Let the saw do the cutting at the rate of speed permitted by the type of cut and
workpiece.

SHARPENING DULL DIAMOND BLADES

If a lot of sparks are seen while cutting, this is a sign that the blade is becoming dull. To create better diamond
exposure (sharpen), make several cuts in a special sharpening stone for diamond blades or alternately use
calcareous sandstone.
MAINTENANCE
Every 50 hours of operation blow compressed air through the motor while running at no load to clean out
accumulated dust. (If operating in especially dusty conditions, perform this operation more often.)
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft
damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the
material. Wear safety glasses while using compressed air.
THE CARBON BRUSHES
The carbon brushes are a normal wearing part and must be
replaced when they reach their wear limit.
To replace: simply remove the brush caps (47) and withdraw
the old brushes (46). Replace with new brushes (always replace
as a pair) ensuring that they align properly and slide freely.
Then replace the brush caps.
Brush Cap
If the replacement of the power supply cord is necessary,
this has to be done by the manufacturer or their agent in
order to avoid a safety hazard.
WARNING: All repairs must be entrusted to an authorized service center. Incorrectly performed repairs
could lead to injury or death.
11