Parallel Guide - AGP SCS7 Instrucciones De Seguridad

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
GB
WARNING: Never use the machine without the PRCD fault-current safety switch supplied.
WARNING: Check all connections of the water feed system to ensure there are no leaks. Inspect hoses
and other critical parts which could deteriorate.
WARNING: If you detect a leak in any part of the water supply system, shut the machine down
immediately and repair the fault.
Quick-release water hose coupling
WARNING: The maximum water pressure should not exceed
70 psi (4 bar).
Water Valve
The water feed system allows the machine to cut more
effectively. Ensure that a PRCD interrupter unit is always used.
Mount the Quick Release Water Coupling to the water supply
hose. Adjust the Water Valve for the desired amount of water
flow.
WARNING: Great care must always be taken to avoid the risk of electrocution whenever using water.
Never allow water to contact the electrical parts of the tool.
Always use a PRCD Interrupter.

PARALLEL GUIDE

The Parallel Guide allows straight cuts to a desired distance from
the edge.
To mount, insert the Parallel Guide into the slot in the Base Plate
and tighten the Thumb Knobs at the desired position.
Parallel guide
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the same as that
On/Off trigger switch
shown on the specification plate of the machine and that switch
is "OFF" before connecting the tool to the power circuit
To switch on:
This machine is equipped with a "LOCK-OFF" switch. To press the
switch, you must first press the release button located at the top
Release Button
of the switch. Then the trigger switch will be free to be pressed to
start the machine.
9
Tabla de contenido
loading

Productos relacionados para AGP SCS7

Tabla de contenido