Diamond Blades; Allowed Types Of Blades - AGP C16 Instrucciones De Seguridad

INTRODUCTION
This machine is equipped with two handles and a blade guard. The motor has overload and overheat
protection. It has an integrated water feed system as required for diamond cutting and has a portable residual
current device (PRCD) for electrical safety. It must only be used with a diamond blade or abrasive wheel.. It
is intended for cutting masonry, stone, concrete, reinforced concrete and similar materials. All other uses are
prohibited.
LIST OF CONTENTS
• Concrete Saw
• Guide Roller Assembly
• M17 Combination Wrench
• Splash Guard
• Flush Cutting Kit (Model C16 only)
ASSEMBLY
• Mount the blade. ( See below "Mounting the Blade")
• Mount the Guide Roller Assembly if desired ( See below "Guide Roller Assembly")
• Mount the blade guard brush (See below "Blade Guard Brush" for assembly instructions)
• Mount the splash guard (See below "Splash Guard" for assembly instructions)

DIAMOND BLADES

Allowed Types Of Blades

This machine may only use diamond blades or abrasive wheels
• Only use either segmented or continuous rim diamond blades.
• If the diamond blades are segmented, the maximum allowable peripheral gap between segments is
10mm and must be with a negative rake angle.
• Model C16: Only diamond blades of 405mm (16") or less may be used.
• Model C14: Only diamond blades of 355mm (14") or less may be used.
• Blade thickness must be at least 2.0mm and no greater than 6.35mm
Blade Storage And Transport
Do not store or transport the machine with the blade mounted. Remove the blade and store in such a way that
it is protected from being bent or damaged when the machine is not in use-this will help prevent damage to
the blade.
A damaged blade can cause irregular conditions, this can cause imbalance and result in a hazard.
Always inspect new blades for storage or transport damage.
GB
8