Makita 7104L Manual De Instrucciones página 5

5-6mm
(3/16"-1/4")
008556
After adjusting the tension, tighten the hex bolt firmly to
secure the chain bar. Additionally tighten slightly the
adjusting screw. Close the chain cover.
To remove the cutter chain, follow the installation
procedures in reverse.
Securing tool to workpiece
3-8mm
2 (1/8"-5/16")
3
008557
1
006005
Loosen the vise lever and move the rear vise backward.
Place the tool on the workpiece so that the front vise
contacts the side of the workpiece. Move the rear vise
forward until the distance between the rear vise and the
workpiece is 3 - 8 mm (1/8" - 5/16") Tighten the vise lever
to secure the rear vise. Move the tool so that the "0" on
the indication plate is aligned with the cutting line (A).
Push the lever (A) down fully to secure the workpiece.
Turn the setting handle until the front edge of the yellow
indicator plate is aligned with the cutting line (B).
1. Lever (A)
1
2. Rear vise
3. Vise lever
1. Setting handle
2. Front vise
2
1
3
006006
OPERATION
006007
Grasp firmly the grips on either side. Switch on the tool
and wait until the cutter chain attains full speed. Then
release the hook and lower the tool head to cut in the
workpiece. Do not apply excessive pressure to the tool.
This may not only decrease the working efficiency but
also cause a dangerous reaction. Feed slowly at the
beginning of a cutting operation, at the time of hole
breakthrough and when cutting a knot in the workpiece.
After cutting, gently raise the tool head until you can hook
the tool head back onto the hook. Then switch off the tool.
Raise the lever (A) and remove the tool from the
workpiece.
WARNING:
Always hook the tool head back onto the hook
•
when not operating the tool.
Never attempt to cut a twisted or warped workpiece
•
which the tool is not secured firmly to.
Adjusting indicator plate and indication plate
The yellow indicator plate and indication plate are factory
adjusted for the standard equipped cutter chain 18 mm
(23/32"). If the alignment is off, for some reason, or when
using another size cutter chain, loosen the screws and
adjust the yellow indicator plate and indication plate.
5
1. Indicator plate
2
2. Indication plate
3. Cutting line (A)
4. Cutting line (B)
4
1. Hook
1