Tabla de contenido
Anleitung_TE_RH_20_SPK8__ 15.06.16 08:18 Seite 18
GB
Always check that the chisel bit or drill bit is
n
firmly locked in the chuck before you start work.
Check the chuck for wear or damage at regular
n
intervals.
Do not start a hammering tool until it is pressed
n
against a workpiece (wall, ceiling, etc.).
Always unplug the hammer drill when you have
n
finished working and remove the chisel bit or drill
bit from the tool.
Always unplug the machine before changing
n
chisel bits or drill bits etc.
Protect eyes and assistants from small flying
n
parts and splinters. Wear a helmet! Erect a
screen wall!
Use workgloves to protect fingers from crushing
n
and skin from grazing.
Vibrations can be harmful to the hand-arm
n
system: Keep the impact time of vibrations to a
minimum.
Always keep the power cable away from where
n
you want to drill.
Keep the machine out of children's reach.
n
Always hold the machine with two hands when it
n
is running and make sure of your footing.
Make sure that the switch on the machine is set
n
to the correct position for the work you want to
perform before you put the machine into opera-
tion. If the switch is not in the correct position you
risk suffering bodily injury when the machine
starts to run.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.
Do not lose these safety instructions.
2.1 Layout (Fig. 1)
1. Dust guard
2. Locking sleeve
3. Selector switch for drill/hammer drill/chisel
4. ON/OFF switch
5. Handle
6. Additional handle
7. Depth stop
8. Locking button
9. Clockwise/counter-clockwise switch
10. Clamping screw
11. Speed controller
18
2.2. Items supplied
Take all the parts out of the packaging.
Check that nothing is missing.
TE RH 20 hammer drill
n
Additional handle
n
Depth stop
n
Drill bit 5x
n
Operating instructions
n
Safety regulations
n
3. Proper use
The tool is designed for drilling with hammer action in
concrete, rock and brick, as well as for chiseling
work, always using the respective correct drill or
chisel bit.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
See warranty card of your country.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
The hammer drill is not designed for outdoors use as
specified I Article 3 of Directive
2000/14/EC_2005/88/EC.
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Tabla de contenido
