EINHELL SB 401 Manual De Instrucciones página 7

Anleitung SB 401-12 sprachig 07.11.2001 7:58 Uhr
1. Description of the machine
1. Base plate
2. Holder
3. Hexagon screw
4. Pillar
5. Table holder
6. Table
7. Tightening screw
16. Handle
19. Machine head
a. Fixing holes
b. Chip guard
2. Items supplied
Scroll chuck of diameter 1,5-13 mm/B16 with
chuck key
Assembly tool
Hinged chip guard
Operating instructions
3. Proper use
The SB 401 is a pillar drill with V-belt drive for
twelve different speed settings. Holes of up to 13
mm diameter can be drilled in vertical direction.
To use the pillar drill properly you must observe
the operating, maintenance and repair
instructions as well as the safety regulations
found in this manual.
The SB 401 is to be used only by persons who
are acquainted with the machine. All the
pertinent accident prevention regulations are to
be observed.
Unauthorized modifications to the machine
release the manufacturer from all liability for any
damage caused as the result.
All work and uses which are not listed require
written approval from Einhell.
To maintain your rights under the warranty and
in the interest of product safety, please observe
the safety regulations.
For design reasons it is impossible to eliminate
all residual risks, namely:
1. Reaching into the chuck and drill when in use
2. Cutting yourself on sharp drill bits
3. Chips being flung out during drilling
4. Clothes becoming caught up in the machine
Seite 7
4. Safety regulations
(Fig. 1)
Wear safety items when drilling.
Always keep long hair suitably covered.
Caution! Long hair gets caught easily in
rotating tools.
Always clamp workpieces with suitable additional
tools.
Check the clamping action of the chuck regularly.
Use only suitable additional tools to extract the
drilling chips.
Caution: Never remove chips with your hand.
Never make adjustments or perform any other
operations on the machine when it is running.
Always use the supplied chuck key to open and
close the scroll chuck.
Caution: Always remove the chuck key after use.
The use of the machine is governed by VDE
guidelines, DIN guidelines and the accident
prevention regulations published by professional
associations.
5. Technical data
Drilling capacity
Drilling depth
Scroll chuck 1,5-13 mm diameter/B 16
Reach
Pillar diameter
Table
Table adjustment
Table angle adjustment 90/0/90 degrees infinitely
Useful area/base plate
Motor speed
Motor rating
Speed
Electrical features
Standing area
Overall dimensions
Weight
Packed dimensions
Sound pressure level LPA
Sound power level LWA
GB
max. 13 mm diameter
52 mm
104 mm
Ø 46 mm
162 x 158 mm
infinitely variable
variable
180 x 140 mm
n : 1400 rpm
0
350 watts - S2 10 min.
640 - 2890 rpm
no-volt tripping
touch-sensitive switch
313 x 198 mm
570 x 420 x 220 mm
18,7 kg
440 x 340 x 220 mm
80 dB/A)
90.6 dB(A)
7