Fagor LA-11 Manual De Instrucciones página 30

The following errors may be found in a washing machine:
ERROR DESCRIPTION
POWER CUT DETECTED
E1
FAULT IN LOCKING
E2
DRAINAGE FAILURE /
E3
WATER IN TUB
MAXIMUM WATER LEVEL
E4
REACHED
FAULT WATER INLET
E5
HEATING FAULT
E6
"MAXIMUM
TEMPERATURE
E7
REACHED"
MOVEMENT ERROR
E8
CAUSE AND ACTION
When the power supply is restored after a power cut has been detected while a
programme is running.
The options "continue" or "end" are displayed. If continue is pressed, the cycle that
was running when the power cut occurred will continue, starting from the
beginning of the cycle again. If "end" is pressed, the programme will end, and the
door is unlocked.
The machine detects that the door cannot be locked at the start of a programme
or that it has unlocked during the programme. This error occurs after 3 attempts to
lock the door every 20 seconds.
The programme will end and the user can try again.
The machine detects that although the "EV drain" or "EV drain 2" output is
activated, the water level in the washing machine tub does not reach "0" within 10
minutes (time can be configured).
The 2 options "continue" or "end" are displayed. If we press continue, the machine
will continue trying to drain but at the end of the established time, the error
message will be displayed again. If we press "end", the door unlocks but the
following warning is given "WATER IN TUB".
If, while a programme is running, a water level is detected which is 80 mm (fixed
value for all models) higher than the maximum safety level. At this moment,
drainage will start through drainage 1.
The option "OK" is given. If this is pressed, the programme will end after the
machine has been completely drained, and the door is unlocked.
The machine detects that although the corresponding solenoid valve outputs are
activated, the water level in the washing machine has not risen 1 mm in 5 minutes
(time can be configured).
The 2 options "continue" or "end" are displayed. If we press continue, the machine
will continue trying to fill but at the end of the established time, the error message
will be displayed again. If we press "end", the programme will end and the door
unlocks.
The machine detects that, in spite of activating the heating output, the water
temperature has not increased by 1ºC within 30 minutes.
It is possible to cancel this error. In this case, instead of triggering an error, the
machine will continue running as if the temperature had been reached.
The 2 options "continue" or "end" are displayed. If we press continue, the machine
does not continue trying to heat the water and the cycle continues as if the
temperature had been reached. If there are more heating phases in the same
programme, the error will be detected again. If we press "end", the programme will
end and the door unlocks.
The machine detects that the water temperature has exceeded 95 ºC.
Only the option "end" is given. When it is pressed, the programme will end, and
the door is unlocked if the temperature is less than 50º. If this is not the case, the
E11 error is triggered: CLOTHES HOT.
The speed sensor does not detect any movement, after the variator has been
ordered to turn the motor (M/P active). There may be several reasons (variator
incorrectly wired, sensor incorrectly fitted, sensor cable broken or poorly
connected, belt not assembled...).
The warning "The programme will end" is displayed and after 2 minutes, the OK
button is shown. Press this to end the programme.
EN
Page 28 of 43