Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.9 –FREEZING
7.9.1– SELECTING AND SETTING OF FREEZING CYCLE
Load the machine suitably with the food to be frozen, place the core probe into the food and close the door.
With the appliance on STANDBY press
: the display will show the set point temperature of the room referred to
-
40°C cycle, in the meantime the icons
and
flash. Use the
and
buttons to edit this value.
Press
(START) to start the cycle: the display will show the temperature of the room and the icons
and
will remain on. As already explained, once confirmed the cycle, the device does an automatic identification of probe's
insertion (around 2 minutes), at the end of which the cycle will be confirmed or by probe or by time. All this process will be
made AUTOMATICALLY.
If the test has a positive result, the device will confirm the temperature controller cycle (probe) and the display will show
the temperature of the probe.
Otherwise, if the result is negative, after buzzer's alarm and visual signalling of the flashing icon
, the display will show
the icon
and the cycle will change in time controlled cycle. Use the
and
buttons to edit this value.
During the visualization of the residual time, it is possible to change the temperature of the room by pressing the buttons
,
,
.
You can DIRECTLY select the cycle time, bypassing the automatic stage of probe recognition.
With the appliance on STANDBY press TWICE
: the display will show the duration of the cycle 240 min, in the
meantime the icons
and
flash. Use the
and
buttons to edit this value. Than press
(START) in
order to start the cycle.
Once finish the time relative to 240' cycle or once reaches the core temperature of -18°C, the device automatically starts
the conservation cycle, -25°C rooms, previously reported by the buzzer's alarm.
On the display will appear the icon
The cycle can be interrupted at any time by pressing
(STOP): press
(START) again in order to restart again
the cycle.
pag. 35
Tabla de contenido
