Device Description - Silca M-SNOOP Manual De Uso

A – Antenna
B – Antenna cable
C – LED signal (1 and 2 )
D – Elastic band
E – Belt
The device is used for data logging to make copies of keys with Megamos
with the machines:
Silca RW4 and P-BOX, FastCopy and P-BOX, and M-BOX ; Ezclone and Plus Box and M-BOX
Silca RW4 PLUS , FastCopy PLUS and M-BOX ; Ezclone Plus and M-BOX
To see the list of vehicle makes and models for which keys can be copied, consult the key blanks in the
Silca catalogues and updates.
See RW4 and FastCopy (Plus) operating manuals:"Copy Megamos
ter.
Environmental conditions: The M-SNOOP working operates at an ambient temperature of -20 to +55°C.
Positioning on the machine (test, reading and writing operations): Place M-SNOOP as shown in the
illustration.
Positioning antenna on key (for use on the vehicle only):
The M-SNOOP antenna must be attached to the head of the key to be copied. See Fig.4.
Place the antenna in the centre of the key head. Secure the antenna to the key with the elastic band (D).

Insert the key with the M-SNOOP antenna attached into the ignition switch.

Turn on the vehicle control panel; LED "1" on M-SNOOP will flash for a few seconds to indicate
that the first data reading operation has been successful.

When LED "1" goes out, turn off the control panel and remove the key.

Wait 10-20 seconds or until the immobilizer warning light starts flashing, if applicable.

Insert the key into the ignition switch again.

Turn on the vehicle control panel; LED "1" on M-SNOOP will go on and LED "2" will flash for a few
seconds to indicate that the second reading operation has been successful.

When LED "1 and 2" goes out, turn off the control panel and remove the key.

Wait 10-20 seconds or until the immobilizer warning light starts flashing, if applicable.

Insert the key into the ignition switch again.

Turn on the vehicle control panel; LED "1 and 2" on M-SNOOP" will flash for a few seconds to
indicate that the third reading operation has been successful. Both LEDs will go out.
M-SNOOP now has the necessary data to transmit to the machine for a copy of the original key. Turning
on the vehicle control panel again will put the M-SNOOP LEDs permanently ON, which indicates that all
the necessary data has been downloaded.

If there are problems during data logging (LEDs do not go on) try:
placing the antenna in a different position so that when the key is in the ignition switch the anten-
na is farther away or nearer to the switch.
Vers.1.0 - March 2016
EQUIPMENT AND WORKING PARTS

DEVICE DESCRIPTION

Use on the vehicle
( Fig.2)
USE
( Fig.3)
( Fig.5)
-3-
M-SNOOP
( Fig.1)
®
Crypto transponders together
®
Crypto (ID48) Transponders" chap-
Copyright 2016