Maintenance; Warranty - Triton TRPUL Instrucciones De Uso

MAINTENANCE

Warning:
Always ensure that the tool is switched off and the plug
is removed from the power point before making any
adjustments or maintenance procedures
Regularly check that all the fixing screws are tight. They
may vibrate loose over time
DRIVE BELT REPLACEMENT
It is suggested that you wear leather gloves to change
the belt in case you make contact with the blades
1. To replace the drive belt first take out the five crosshead
screws that secure the drive belt cover on the left-hand
side of the planer as viewed from the rear
2. Remove the damaged belt and use a soft brush to clean
the pulleys and the surrounding area
Note: Wear eye protection when cleaning out the pulley
area.
3. With the four continuous 'v' profiles on the inside, place
the new belt over the bottom pulley Half fit the other
end of the belt on the top pulley then roll the belt in
place whilst turning the pulley
4. Check that the belt runs evenly by manually turning
the belt
5. Replace the cover and the five fixing screws
6. Connect the tool to the power supply and run the planer
for a minute or two to make sure that the motor and
belt are operating correctly
GUARANTEE
To register your guarantee visit our web site at
www.tritontools.com* and enter your details.
Your details will be included on our mailing list (unless
indicated otherwise) for information on future releases.
Details provided will not be made available to any third party.
GB
PURCHASE RECORD
Date of Purchase:
Model: TRPUL
Retain your receipt as proof of purchase
Maintenance / Guarantee
10
___ / ___ / ____
CLEANING
1. Keep the tool's air vents unclogged and clean at all
times
2. Remove dust and dirt regularly. Cleaning is best done
with compressed air or a dry, soft to medium brush like
a paint brush
Warning: Wear protective goggles when cleaning the tool
3. Re-lubricate all moving parts at regular intervals
4. Never use caustic agents to clean plastic parts. A mild
detergent on a damp cloth is recommended. Water
must never come into contact with the tool Ensure the
tool is thoroughly dry before using it
POWER CORD MAINTENANCE
If the power cord needs replacing, the task must be
carried out by the manufacturer, the manufacturer's
agent, or a power tool repair centre in order to avoid a
safety hazard
Triton Precision Power Tools guarantees to the
purchaser of this product that if any part proves to
be defective due to faulty materials or workmanship
within 12 MONTHS from the date of original
purchase, Triton will repair, or at its discretion
replace, the faulty part free of charge.
This guarantee does not apply to commercial use
nor does it extend to normal wear and tear or
damage as a result of accident, abuse or misuse.
* Register online within 30 days.
Terms & conditions apply.
This does not affect your statutory rights