Craftsman CMXGWAS020733 Manual Del Operario página 9

Check Water Inlet Screen / Connect Garden Hose
1 . Inspect inlet screen . Remove debris or replace if
damaged .
2 . Run water through garden hose (not to exceed 50
ft (15 m) to clean out debris, then connect to water
inlet .
NOTICE There must be at least 10 ft (3 m) of unrestricted
garden hose between the pressure washer inlet and any
device, such as a vacuum breaker, to prevent pump
damage .
3 . Turn on water, point spray gun in safe direction, press
trigger lock and depress trigger to purge pump system
of air .
4 . Attach spray wand to spray gun . Tighten by hand .
Step 4: Spray Tips
1 . Select desired spray tip:
Inlet Screen
2 . Pull spray wand quick connect collar back, insert
Low Pressure
Black Soap
Use to apply
detergent
General Rinse
Yellow, 15°
Siding /
Patios Decks
Driveways /
Garage Floors
spray tip and release . Tug spray tip to ensure it is
secure .
Operation
Delicate Rinse
White, 40°
Cars / Vans /
Trucks / Outdoor
Furniture
Maximum Rinse
Red, 0°
Paint Removal /
Oil Stains /Rust
Removal
9