Craftsman CMXGWAS020733 Manual Del Operario página 8

Operation
1 . Slowly remove fuel cap to relieve pressure in tank .
2 . Slowly add fuel to fuel tank . Do not fill above bottom
of fuel tank neck to allow for fuel expansion .
3 . Install fuel cap and let any spilled fuel evaporate
before starting engine .
High Altitude
At altitudes over 5,000 ft (1524 m), a minimum
85 octane fuel is acceptable . To remain emissions
compliant, high altitude adjustment is required . Operation
without this adjustment will cause decreased performance,
increased fuel consumption, and increased emissions .
See an authorized Briggs & Stratton dealer for high
altitude adjustment information . Operation of the engine at
altitudes below 2,500 ft (762 m) with the high altitude kit
is not recommended .
Transporting
Do not tip engine or equipment at an angle which causes
fuel to spill .
Step 3: Set Up
Clean Debris
Clean any accumulated debris . Keep area around muffler
free from any debris .
• Use a soft bristle brush to loosen caked on dirt or oil .
• Use a damp cloth to wipe exterior surfaces clean .
Lubricate O-rings
Lubricate all connections shown to extend the life of the
o-rings .
1 . Inspect and clean connecting surfaces prior to
lubrication and assembly . Replace o-rings that are
damaged or missing . See Common Service Parts.
NOTICE Never repair leaking connections with sealant of
any kind . Replace o-ring .
8
Maximum Fill Level
2 . Use a small brush or cotton swab to apply a light
coating of grease directly to o-rings .
Spray Gun
Spray Wand
Check / Connect Gun and Hose
1 . If spray gun trigger depresses without pressing trigger
lock or if spray gun remains depressed when released,
replace spray gun immediately .
Trigger Lock
2 . If high pressure hose is damaged, exposing inner
mesh, replace immediately .
3 . Attach high pressure hose to spray gun and high
pressure outlet on pump . Tighten by hand .
WARNING! The high pressure fluid could cut
through skin and its underlying tissues, resulting
in serious injury and possible amputation . Never
attach spray wand directly to high pressure hose .
High
Pressure
Hose
Craftsman.com