Cleaning, Care & Maintenance - Eurofred S/S Counters Serie Manual De Instrucciones

Function
Note: For safety reasons the keyboard locks automatically after 30s of keys inactivity.
To execute any operation, please unlock the keyboard first.
How to see and modify the set point

Push and immediately release the

To change the set value push

To memorize the new set point value push the
Automatic defrost

The appliance will automatically run defrost cycles.
Note: the cycle starts from the time the appliance is initially powered up.
To manually defrost the applicance:
 Press and hold the DEFROST

The defrost cycle will start immediately and the Defrost
Note: Starting a manual defrost also resets the automatic defrost timer. The next automatic defrost
will start according to the set parameter after the manual defrost has finished.
How to turn the machine in ON / STAND -BY status

Press and hold the
vice-versa.

During the button hold the
Cleaning, Care & Maintenance
Routine maintenance
Switch off and disconnect from the power supply before cleaning.

Clean the enclosure and interior of the appliance as often as possible.

Clean the unit with moist cloth. Never allow the switch, control panel, cable or plug to get wet.

Do not use abrasive cleaning agents. These can leave harmful residues. Use only mild soapy
water.

Clean the door seal with water only.

Ensure that no cleaning water penetrates into the electrical components.

Must not be cleaned by a water jet.

Always wipe dry after cleaning with soft cloth.

Do not allow water used in cleaning to run through the drain hole into the evaporation pan.

Take care when cleaning the rear of the appliance.

An agent or qualified technician must carry out repairs if required.

If the appliance is to be left inactive for long periods, unplug the appliance after having turned
the switch to OFF position, empty the refrigerating compartment and clean thoroughly.
Special maintenance
The instructions given in the following paragraph are for SKILLED PERSON.
Periodic Operations

Periodically clean the condenser using suitable tools (vacuum cleaner or soft brushes).

Check that the electrical connections are not loose.

Check that the thermostat and the sensor are in proper working order.
P2M026STD-Ver1.1
key, the set point will be showed and starts blinking;
or arrows within 20s.
button for 3s;
key for 4s, the machine will turn from ON to STAND -BY status and
LED will blink to show status changing.
7
key again or wait 20s .
LED illuminates.
GB