Function - Eurofred S/S Counters Serie Manual De Instrucciones

Installation
Fit the shelves/drawers
Note: If the unit has not been stored or moved in an upright position, let it stand upright for
approximately 12 hours before operation.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.
Note: This is vital for ensuring correct drainage of condensation.
• Place one pair of guides on either side of the cabinet at the desired height.
• Slide the shelf/drawer into place.
• Repeat for the remaining shelves.

Function

Storing food
To get the best results from your appliance, follow these instructions:

Only store foodstuffs in the appliance when it has reached the correct operating temperature.

Ensure GN container bays are full at all times, even if the GN containers are unused or empty.
Empty bays will greatly reduce efficiency of the appliance.

Always close the door lid or drawer when not in use.

Do not place uncovered hot food or liquid inside the appliance.

Wrap or cover food where possible.

Do not obstruct the fans inside the appliance.

Avoid opening the doors/drawers for prolonged periods of time.

The maximum load for a shelf/drawer is 30 kg.

The food must be put into container before placed into cabinet or on the shelf. Food must not
be placed into food cabinet directly.

When wet food/vegetable is put in the Saladette, it's normal that ice (snow) appears on the
surface.
Turn on

Close the door/lid/drawer of the appliance.

Ensure the power switch is set to [ O ] and turn on at the socket.

Switch on the Power [ I ]. The current temperature within the appliance is displayed.

The on the control panel will flash for 3-min to indicate a delay between the motor compressor
being stopped and then restarted.
Open/close the lid or drawer
WARNING: The sliding lid does not have a locking mechanism. Always make sure that the lid is in
the 'half-open' position before opening.
WARNING: Do not pull the drawer out of its full open position to avoid any hurt.
The lid of the GSA is multi-positional:

With the lid closed, slide the panel back into the half open position. This allows partial access to
the GN container trays.

Lift the lid up and back so the hinge settles into the support slot.

Lift the lid up and completely back so the GN container trays are completely exposed.
P2M026STD-Ver1.1 5 GB