Important Instructions; Items Supplied; Intended Use; Additional Safety Instructions - ALPHA-TOOLS A-FS 1800 UG Manual De Instrucciones

Anleitung A-FS 1800 UG_SPK7:Anleitung TPR 180 UG_SPK1
GB
Wear safety gloves
Wear safety goggles
Wear ear-muffs
Wear a dust mask
1. Layout (Fig. 1/2)
1. Diamond wheel
2. Trough
3. Work table
4. Angle stop
5. Rail fence
6. Chain bar
7. Safety hood for the cutting wheel
8. Handle
9. Star grip screw for setting the angle
10. Star grip screw for securing during transportation
11. Star grip screw
12. ON/OFF switch
13. Motor

2. Items supplied

Tile cutting machine
Base frame

3. Intended use

The tile cutting machine is designed for the standard
cutting of small and medium-size tiles (glazed tiles,
ceramic tiles or similar) which can be accommodated
by the size of the machine. It is designed for DIY
applications and craft businesses in particular. It
should never be used for the cutting of wood or
metal. The machine should be used exclusively
for its intended purpose. No other use is permitted
and the manufacturer will not accept liability for any
damages or injury resulting from any such use;
responsibility rests with the user/operator in any such
case. Only use cutting wheels which are suitable for
the machine. Saw blades should never be used.
Compliance with the safety instructions, the
assembly instructions, and advice and instructions
on operation contained in the operating instructions
also falls under the terms of intended use. All
persons operating or carrying out maintenance work
on the machine must be acquainted with the above
8
and be aware of all potential dangers.
In addition, strict compliance with the accident
prevention regulations in force in your area, as well
as all other general rules of health and safety at
work, is imperative. The manufacturerʼs liability shall
be deemed void if the machine is modified in any
way and the manufacturer shall therefore accept no
liability for any damages arising as a result of
modifications. Even if the machine is used as
intended, certain residual risk factors cannot be
completely eliminated. For reasons of design and the
construction of the machine, the following
eventualities are possible:
Contact with the diamond cutting wheel where it
is not covered.
Contact with the diamond cutting wheel while it is
turning.
Defective diamond tips flying off the cutting
wheel.
Workpieces or parts of workpieces kicking back.
Damage to hearing if the ear-muffs specified are
not used.

4. Important instructions

4.1. General
Please read this manual carefully and pay particular
attention to the instructions contained within it. Use
this information to get to know the machine, its
correct operation and safety regulations before using
for the first time.

4.2. Additional safety instructions

Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
Check that the voltage on the rating plate is the
same as your supply voltage. Only then are you
to insert the power plug in the socket-outlet.
Wear safety goggles.
Wear ear-muffs.
Wear safety gloves.
Never use cracked diamond cutting wheels.
Replace immediately.
Never use segmented cutting wheels.
Caution! The cutting wheel runs on after the
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Caution! The diamond cutting wheel must be
cooled with water at all times.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels.
13.10.2006 9:18 Uhr Seite 8