Ordering Replacement Parts - ALPHA-TOOLS A-FS 180/2 Manual De Instrucciones

Anleitung A-FS 180-2_SPK7:Anleitung FSG 518-1 SPK 1
sure that the diamond wheel does not touch the
glaze on the tile. Correct the cutting guiding
position if necessary.
Fig. 5 shows the correct position for your hands
during miter cutting to 45°. The right hand holds
the workpiece in contact with the diamond wheel
while the left hand pushes the workpiece forward.
The rate of advance must not exceed the cutting
capacity of the wheel. This is to make sure that no
material comes off, as this may cause accidents
or injuries.
9. Maintenance
Remove dust and dirt regularly from the machine.
Cleaning is best carried out with compressed air
or a cloth.
Never use caustic agents to clean plastic parts.

10. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
29.11.2006 9:04 Uhr Seite 9
GB
9