ABAC Hose Reel G-610 Instrucciones De Uso página 70

EN
Automatic hose reel 6/10mm
B
A
Before connecting accessories make sure the compressor is shut down.
Connect only tools or accesories operating at a pressure greater than the supply pressure.
Do not kink, step on or press the hose with heavy and sharp objects.
Suspend immediately the supply pressure in case any leaks occurs and contact the manufacturer.
Use soap and water when checking for air leaks.
Suspend immediately the supply pressure in case the reel winding system fails.
Pull the hose by grasping the pipe and not the valve.
Avoid releasing the hose suddendly while winding or unwinding.
The mechanism is under tension and releasing the hose could cause uncontrolled spinning and personal injury.
ACCESSORIES
Only use accessories and consumables that are designed for the use with this tool.
Select the best available inserted/mounted accessories/consumables for the lowest possible noise level and vibration.
Replace them in case of an increased noise level and/or vibration.
Make sure that the inserted/mounted tool/accessory is properly held by the retainer and make sure that the retainer
is in good condition. Never use the tool without a retainer as this may cause high speed projectiles.
Only use sharp chisels, as blunt chisels require excessive pressure and can break.
Never cool down a hot tool/accessory as this may influence the hardness causing dangerous circumstances.
Use the inserted/mounted accessory/tool according the manufacturer specifications.
USING A PNEUMATIC TOOL
DO NOT operate the tool freely, It must always be in contact with the work surface. Failure to do so can cause
Retainer, Cylinder or housing failure which may result in injury to the operator and will invalidate warranty.
If a chisel is released by the retainer whilst in use, stop the tool immediately and re insert the chisel.
Before start using the tool, make sure that you are familiar with the workplace and surrounding area.
Always obey the safety regulations for the work area you are working in.
Hold the tool always firmly with both hands.
70