Troubleshooting - Zanussi ZRB935NX2 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Defrosting of the refrigerator
Frost is automatically eliminated from the evapo-
rator of the refrigerator compartment every time
the motor compressor stops, during normal use.
The defrost water drains out through a trough
into a special container at the back of the appli-
ance, over the motor compressor, where it
evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water over-
flowing and dripping onto the food inside. Use
the special cleaner provided, which you will find
already inserted into the drain hole.

Troubleshooting

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent person
must do the troubleshooting that is not in this
manual.
Problem
The appliance is noisy.
The compressor operates
continually.
www.zanussi.com
Possible cause
The appliance is not supported
properly.
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
The Action Freeze function is
switched on.
Defrosting of the freezer
The freezer compartment of this model, on the
other hand, is a "no frost" type. This means that
there is no buildup of frost when it is in opera-
tion, neither on the internal walls nor on the
foods.
The absence of frost is due to the continuous
circulation of cold air inside the compartment,
driven by an automatically controlled fan.
Important! There are some sounds during
normal use (compressor, refrigerant circulation).
Check if the appliance stands stable
(all the four feet should be on the
floor).
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
Refer to "Action Freeze function".
Solution
11
Tabla de contenido

Solución de problemas

loading

Tabla de contenido