Hoover Athyss AS71 AS20011 Manual De Instrucciones página 5

DO NOT use the vacuum cleaner without the pre-motor filter in place.
Replace the standard pre-motor filter after five full bags have been used.
REPLACING THE EXHAUST FILTER
Lift off filter cover. [Fig. 12]
1.
Peel off filter, fit new filter and replace cover. [Fig. 13]
2.
DO NOT use cleaner without the exhaust filter in place.
Replace the exhaust filter after five full bags have been used.
USING IN BAGLESS MODE*
This product can be used in bagless and bagged mode. This section will describe how to
use the product with free bagless cassette and the relative filters.
MPORTANT: switch cleaner Off and remove plug from electricity supply before removing
the bag.
TO CHANGE FROM THE BAGGED TO BAGLESS MODE*
Please follow the following steps:
a) Lay the cleaner on a flat surface, pull back the door release button and remove the
transparent door.
b) Remove the bag.
c) Fit the bagless cassette.
e) Locate tabs on door and close door.
EMPTYING THE BAGLESS CASSETTE*
a) Lay the cleaner on a flat surface, pull back the door release button and remove the
transparent door.
b) Remove the bagless cassette.
c) Remove the cassette closure (red) by rotating the container and upper closure in
opposite directions.
d) Empty the debris from the container into a bin. Check if it is necessary to clean the
relative filters, as described in the "Maintaining the bagless filters" section.
e) To refit the bagless cassette and the filters to the product, simply repeat all steps in
reverse.
NOTE: Hoover recommends to inspect and wash if necessary, the cassette and the
filters after each full container, see maintaining filters section.
MAINTAINING THE BAGLESS FILTERS*
a) To access the washable HEPA filter (BLUE), rotate the mesh filter in the opposite
direction from the cassette upper closure and remove the mesh.
b) Gently tap filters to release excess dust.
c) Wipe clean the mesh filter (RED) and wash thoroughly the HEPA filter from the
inside under hand warm water until the water runs clean.
d) Remove excess water by shaking and leave to dry for 24 hours. Refit filters to the
cleaner only when completely dry.
DO NOT USE HOT WATER OR DETERGENTS.
MPORTANT: Ensure the bagless filters, mesh and HEPA, are fitted before use.
SPECIALITIES
FOLDAWAY HANDLE
1. To use the product as portable vacuum cleaner together with the accessories, press
the handle release button and fold the handle backwards until it clips into place at
the base of the main body. [Fig. 14,15]
Fold handle for easy storage. [Fig. 16]
2.
MINI POP-UP HANDLE
As main handle is folded backward the Mini Pop-Up handle automatically rises to allow
the product to be easily carried or used as a portable vacuum cleaner. [Fig. 17]
NOZZLES
Carpet & Floor and Carpet* nozzles
1. secure the nozzle to the product. [Fig. 18]
Press the floor type selector pedal on the nozzle [19] to select the ideal cleaning
mode for the floor type.
Hard Floor – Brushes are lowered to protect the floor.
Carpet – Brushes are raised for the deepest clean.
2. Parquet nozzle* for wooden and delicate floors.
ACCESSORIES
To obtain the best performance and energy efficiency #1 it is recommended that the
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as
required by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
3
*Certain Models Only ** Certain models only, nozzles may vary according to model
GB