Technical Characteristics - Erreka EP1-008 Manual De Instrucciones

Before you start with the installation of this control set you must read thoroughly this
instructions manual and carry out the connections according to the guidelines. A scheme
is included to make the connections easier.
Any connection that is not realised properly can produce personal damage and /or
irreparable failures in the product.
We recommend that the installation to which we connect the control set fulfils the
conditions of the low voltage specifications in force.
Before realising any connection or manipulation of the control set, you must disconnect it
from the power supply.
When you install the actuator and/or the peripherals, you must disconnect the power
supply of the control set.
.- Power supply: 220V AC /50 Hz.
.- Single-phase actuators with permanent capacitor are allowed.
.- Suitable for actuators with time stop or limit switches.
.- Regulation of the Opening time (TO), the Closing time (TC), as well as the Waiting time
(WT) through independent digital timers (analogue timers in the model EP1-008).
.- Possibility to insert a:
- Radio receiver with decoder
- Traffic signal card or a sparkling light card
.- Miniature relays with capacity for electric contact up to 16A.
.- Output for the electro-closure of 17V direct current.
.- Motor and control set protection fuse of 2,5A.
.- Protection against over voltage through a barretter up to 275 VAC.
.- Supplied in a watertight box IP55.
.- Equipped with different LED indicators to show the operations:
- Key LED (L1); switches on when you push the key or the remote control.
- Photocell LED (L2); switches off when you interrupt the light beam of the photocell.
- Wait state LED (L3); stays switched on during the waiting time (WT).
- Power supply of the control set LED (L4): stays switched on when the control set is on duty.
IMPORTANT! PRELIMINARY CONDITIONS

TECHNICAL CHARACTERISTICS

19
Model AEP1-08M is
designed to work with
a tension of 125V and
an intensity of 6A.