TRAPP BIO 300 s Manual De Instrucciones página 53

www.trapp.com.br
Exit nozzle
In the outlet spout there are several round stems
fixed that serve as sieve and determine the size of
the crushed material. The more stems are
mounted on the outlet spout, the smaller the
material size. To remove the stems, observe
Figures 4 and 5 and following instructions:
Remove the fixation clips (1).

Pull the pins of the removable bars (2).

Remove the removable bars (3).

1
Image merely illustrative
Figure 4
Image merely illustrative
Figure 5
3
2
Insert the material to crush
Observe the size of the material to be crushed and

follow the recommendations before inserting the
material into the upper or side hopper.
With all stems mounted to the crushed material

output, it takes longer to leave the crusher and may
overload the machine's engine. In this case, reduce
the amount of material to be crushed and select the
material before the crushing.
When using the crusher, be careful not to exceed

the crusher feed and pay attention to the
accumulation of material in the outlet spout,
removing excess with a shovel or a hoe.
Try mixing the crushed materials for good

composting if you wish to use the crushed material
in flower beds, separate the green from the wood
trunks when crushing and allow the material to dry
after being crushed before use in the beds.
Organic matter should not be wet because a

blockage can occur in the outlet nozzle
The ejected material must be constantly

monitored to avoid possible obstruction of the
outlet nozzle. When the blockage of the outlet
nozzle occurs immediately unplug the unit.
Attention!
The motor may burn due to overload if an
excessive amount of material is introduced
into the feeder funnel.
53