OHAUS TD52 Manual De Instrucciones página 4

EN-2
3. Connect the 12-pin Cable Connector included with the kit to the
Main Board Connector 2. Place the ferrite in the slot of the rear
housing as shown.
4. Install the Analog Current Loop board in the indicator using 2 screws as
shown. Connect the 12 pin connector cable from the main board to the
Analog Current Loop board 12 pin connector.
5. Connect the current loop cable to the 3 pin and 3 pin connectors.
Cable
Ferrite
Main board connector
2
3 Pin / 3 Pin connector
Current Loop Cable
Screw
12 Pin connector