Tabla de contenido
Idiomas disponibles
Idiomas disponibles
STEP I
1.
Attach the Rear Stabilizer (3) to the Base Frame
(1) and tighten by X2 Hex Head Bolt (30), X4
Washer (34) and X2 Nylon Nuts (38).
2.
Attach the Front Stabilizer (4) to the Base Frame
(1) and tighten by X4 Hex Head Bolt (30), X8
Washer (34) and X4 Nylon Nuts (38).
3.
Attach the Upright Support Tube (2) to the Base
Frame (1) and tighten by X2 hex Head Bolt (30),
X4 Flat Washer (34) and X2 Nylon Nuts (38).
STEP 2
1.
Connected Bracket for Cloth Cover (73R)
to the Rear frame with 2X Bolts(77) and 2X
Washers(78). Repeat in the same manner to
connected the Bracket for Cloth Cover(73L).
2.
Slide both Guiding Tube (5) through Rubber
Ring (47) into the 2 holes on the Rear
Stabilizer (3), tighten from the bottom side
by X2 Curve Washer (33) and X2 Hex Head
Bolt (22).
3.
Place the Weight Stack (63) into the Guiding
tube (5). (Watch out personal safety)
4.
Place the Bushing for Weight Stack (55) onto
the Select Bar (12) and fixed by the Fixed Pin
(40). Then place the Weight Stack (62) upper
the Select Bar (12) and place the Flat Washer
(36) upper the Weight Stack (62).
5.
Insert the Select Pin (32) through the Weight
Stack (63) into the hole of Select Bar (12)
32
Tabla de contenido
