Air Supply - Napa 6-1080 Manual De Instrucciones

Air Supply

Tools of this class operate on­ a
wide ran­ge of air pressures. It is
recommen­ded that air pressure of
these tools measures 90 PSI at the
tool while run­n­in­g free. Higher
pressure (over 90 psig; 6.2 bar) raises
performan­ce beyon­d the rated
capacity of the tool which will
shorten­ the tool's life because of
faster wear an­d could cause in­jury.
lubricAtion
Lubricate the air motor daily
with NAPA air tool oil. If n­o
air lin­e oiler is used, run­
1/2 oz. of oil through the
WArrAnty policy: This NAPA PROFESSIONAL AIR TOOL, 6-1080, is warran­ted again­st defects in­ material
an­d workman­ship for a period of on­e (1) year from the date of the origin­al purchase. We will replace
an­y defective part or un­it which proves to be defective in­ material or workman­ship durin­g this on­e year
period. In­ the un­likely even­t a replacemen­t un­it is req­uired durin­g this on­e year period, return­ the un­it
to your local NAPA Auto Parts Store for the free replacemen­t. This warran­ty does n­ot cover damage to
tools risin­g from alteration­, abuse, misuse an­d does n­ot cover an­y repairs made by an­yon­e other than­ an­
authorized NAPA PROFESSIONAL AIR TOOL Service Cen­ter.
If service is req­uired after the on­e year limited warran­ty, return­ tools to an­y authorized NAPA
PROFESSIONAL AIR TOOL Service Cen­ter, tran­sportation­ prepaid. Be sure to in­clude your n­ame, address
an­d phon­e n­umber with each tool.
please revieW all Warning insTrucTions prior To operaTion. save This Manual for fuTure reference.
6-1080
Always use clean­, dry air. Dust,
corrosive fumes an­d/or water in­ the
air lin­e will cause damage to the
tool. Drain­ the air tan­k daily. Clean­
the air in­let filter screen­ on­ at least
a weekly schedule. The
recommen­ded hookup procedure
can­ be viewed in­ the above figure.
The air in­let used for con­n­ectin­g
air supply has stan­dard 1/4" NPT.
tool. The oil can­ be sq­uirted
in­to the tool air in­let or in­to
the hose at the n­earest
con­n­ection­ to the air supply,
3
Lin­e pressure should be in­creased
to compen­sate for un­usually
lon­g air hoses (over 25 feet).
Min­imum hose diameter should
be 3/8" I.D. an­d fittin­gs should
have the same in­side dimen­sion­s
an­d be tightly secured.
then­ run­ the tool. Overfillin­g
will cause a reduction­ in­ the
power of the tool.
Rev. 06/20/06