Storage And Distribution Of The Documentation; Target Group For The Instructions; Personnel Qualification - HEIDENHAIN ND 200 Manual De Instrucciones

Installation Instructions en
1.3 Storage and distribution of the
documentation
These instructions must be kept in the immediate vicinity of
the workplace and must be available to all personnel at all
times. The operating company must inform the personnel
where these instructions are kept. If the instructions have
become illegible, the operating company must obtain a new
copy from the manufacturer.
If the product is handed over or sold to a third party, the
following documents must be given to the new owner:
Addendum, if supplied
Installation Instructions
Operating Instructions
1.4

Target group for the instructions

The Installation Instructions must be read and observed by
every person who performs any of the following tasks:
Mounting
Installation
16
2 Safety
General accepted safety precautions, in particular the
applicable precautions relating to the handling of live
electrical equipment, must be followed when operating the
system. Failure to observe these safety precautions may
result in personal injury or damage to the equipment.
It is understood that safety rules within individual
companies vary. If a conflict exists between the material
contained in these instructions and the rules of a
company using this system, the more stringent rules take
precedence.
2.1

Personnel qualification

The personnel for mounting and installation must be
appropriately qualified for this work and must have obtained
sufficient information from the documentation supplied with
the product and with the connected peripherals.
The personnel required for the individual activities to be
performed on the product are indicated in the respective
sections of these instructions.
The personnel groups that are responsible for mounting and
installation have different qualifications and tasks, which are
specified as follows.
Qualified personnel
The qualified personnel are trained by the operating
company to perform advanced operation and
parameterization. The qualified personnel have the required
technical training, knowledge and experience and know the
applicable regulations, and are thus capable of performing
the assigned work regarding the application concerned and
of proactively identifying and avoiding potential risks.
Electrical specialist
The electrical specialist has the required technical training,
knowledge and experience and knows the applicable
standards and regulations, and is thus capable of performing
work on electrical systems and of proactively identifying
and avoiding potential risks. Electrical specialists have been
specially trained for the environment they work in.
Electrical specialists must comply with the provisions of the
applicable legal regulations on accident prevention.
ND 200