Dremel 300 Serie Instrucciones De Funcionamiento Y Seguridad página 10

DISPOSAL
The machine, accessories and packaging should be sorted for
environmental-friendly recycling.
GENERAL SPECIFICATIONS
Voltage Rating
. . . . . . . . . . . . . .
Amperage Rating
. . . . . . . . . . .
No Load Speed
. . . . . . . . . . . . . .
Collet Capacity
. . . . . . . . . . . . .
EXTENSION CORDS
Use completely unrolled and safe extension cords with a
capacity of 5 Amps.
ALWAYS UNPLUG MULTITOOL BEFORE CHANGING
ACCESSORIES, CHANGING COLLETS, OR SERVICING
THE TOOL.
GENERAL
The Dremel multitool is a high quality precision tool that can be
used to perform detailed and intricate tasks. The wide range of
Dremel accessories and attachments allow you to perform a
large variety of tasks. These include tasks such as sanding,
carving and engraving and routing, cutting, cleaning and
polishing. PICTURE 2
PICTURE 1
A. Collet nut
B. Collet
C. Housing cap
D. Attachment interface
E. Shaft Lock Button
F. On/Off Switch and Variable Speed Dial
G. Brush cover (one each side)
H. Ventilation openings
I. Hanger
J. Collet Wrench
K. Power cord
ENVIRONMENT
SPECIFICATIONS
220-230 V, 50-60 Hz
0.5A
n 33,000/min
o
0,8mm, 1,6mm, 2,4mm, 3,2mm
ONLY FOR EC COUNTRIES
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC for
Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that are
no longer usable must be collected separately and
disposed of in an environmentally correct manner.
MOTOR SPECIFICATIONS
This multitool utilizes a variable high speed motor. It is wired
for operation on 220-230 volts, 50-60 Hz. Always check that
the supply voltage is the same as the voltage indicated on the
nameplate of the tool (tools with a rating of 230V or 240V can
also be connected to a 220V supply).
ASSEMBLY
The Dremel accessories available for the multitool come
with various shank sizes. Four size collets are available to
accommodate the different shank sizes. Collet sizes are
identified by the rings on the back of the collet.
PICTURE 3
L. 3,2 mm Collet without ring (480)
M. 2,4 mm Collet with three rings (481)
N. 1,6 mm Collet with two rings (482)
O. 0,8 mm Collet with one ring (483)
NOTE: Some multitool kits may not include all four collet sizes.
Collets are available separately.
Always use the collet which matches the shank size of the
accessory you plan to use. Do not force a larger diameter shank
into a smaller collet.
10
COLLETS