Location Of Controls - Jocel JSE013415 Manual De Instrucciones

LOCATION OF CONTROLS

1. Thermostat control knob ( TEMPERATURE SETTING)- Adjust to maintain room temperature
2. Flame switch - Switches flame effect and power on/off
Heating setting: please press "
3.
Heating setting : please press "
4.
without first press
5. Flame dimmer control - Adjust to set flame intensity
OVERHEATING SAFE DEVICE
If the fireplace stops working, turn the fireplace off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 10 minutes for the protection system to reset before
attempting to restart the fireplace. If the safe device still switches the fireplace off and makes the
fireplace fail to operate, take the fireplace to your nearest service center for examination or repair.
Attention: before restarting the fireplace, the plug must be disconnected for at least 10 minutes
CLEANING
1. Always disconnect the appliance from the main supply before cleaning.
2. Clean the outside of the fireplace by wiping with a damp or dry cloth.
3. Do not use petroleum, any other detergent or chemical solvent to clean the fireplace.
4. When the fireplace is not used for a long time, it should be protected from dust and stored in a
clean dry place.
DISPOSAL
Environmental Protection
Waste electrical production should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
" for 1000W
" and "
" ")
" at the same time for 2000W (can not operate
-15-