Cascade 35D Instrucciones De Montaje página 5

B. Installation (Continued)
6 Install stop block kit 669344 (Class 3) or 670704 (Class 4)
to prevent the attachment from shifting on the truck carriage.
Position each stop block on the truck upper carriage bar
approximately 1.5 mm from the outward side of each upper
mounting hook. If the carriage bar is not wide enough,
place the stop blocks on the inward side of the hooks.
Preheat the upper carriage crossbar weld area and
stop block to 200
CAUTION: Protect all hydraulic hoses and components
from excess heat and weld splatter.
Ground the welder to the truck carriage. Use AWS E-7018
low hydrogen rod and weld a 6 mm fillet as shown.
Let the weld slow cool.
7 Connect hydraulic hoses to the attachment fittings using
Installation Kit 672442 for standard revolving clamps,
Kit 659245 for clamps with solenoid adaption OR use
hoses and fittings as shown. Position the truck carriage
behind the attachment to determine hose lengths required
to connect hoses to the hose terminal fittings. Remove
the hoses and cut to length as required.
Open
No. 6 Hoses
(SAE 100 R1)
CAUTION: Flush the hoses as follows to prevent damage
to the attachment hydraulic components.
8 Connect the hoses to the truck hose terminal kits. Connect
the hoses together using union fittings. Start the truck and
actuate the truck control valves in both directions for about
30 seconds to carry any debris left in the hoses to the truck
hydraulic tank and filter.
9 Remove the union fittings. Connect the hoses to the
attachment fittings. See the chart below for correct
auxiliary valve and attachment function operation.
Function, in
sequence of
location to
the operator
Rotate
Clamp*
* If solenoid equipped, depress button for CLAMP/RELEASE
functions. Release button for ROTATE.
Cascade
o C.
Rotate CCW
Rotate CW
Clamp
Attachment Motion of the operator's hand
Movement when actuating the truck auxi-
liary control handle while
facing the load
Clockwise Rearward or Up
Counterclockwise Forward or Down
Clamp Rearward or Up
Release Forward or Down
No. 8 Hoses
(160 bar max. work
Rotate CCW - De-energized
pressure)
Clamp - Energized
5
1.5 mm
Rotate CW - De-energized
Open - Energized
8
Installation Instruction
Upper mounting
hook
6
Steel
stop block
Truck
carriage
upper
fork bar