Cascade 35D Instrucciones De Montaje página 4

B. Installation (Continued)
3 CAUTION: Remove the plastic cover from the drive
assembly relief fitting. Check oil level in drive assem-
bly. Oil level must be visible in fill hole. Fill if neces-
sary with Cascade Gear Lube 656300 or equivalent
SAE 90 wt. lube (AGMA "mild" 6EP Gear Oil).
4 Center the lift truck behind the attachment. Engage
the upper mounting hook tab with the closest upper
carriage bar notch and raise the truck carriage into
position behind the attachment. Lift the attachment
5 cm off the pallet.
WARNING: The mounting hooks must be
properly engaged with the upper carriage
bar. The tab on the left mounting hook must
be engaged in the mating notch on the upper
carriage bar.
5 Engage the lower hooks with the truck lower carriage bar.
Bolt-On Hooks - Install the hooks and capscrews.
Tighten the capscrews finger tight. Tap the end of the
hooks with a hammer in the direction of the adjust arrow
for maximum engagement with the carriage bar.
Tighten the capscrews to a torque of:
Class 3: 142-155 N.m.
Class 4: 250-270 N.m.
Quick Change Hooks - Remove the locking pins.
Slide the hooks up to engage with the carriage bar.
Install the locking pins through the upper holes.
WARNING: If the clearance between the
carriage bar and the hooks exceeds 5 mm,
the guides (refer to step 2) should be inverted
and installed with the hole offset downward -
16 mm from bottom of guide to hole center,
to minimize the gap.
Installation Instruction
3
The tab on the left mounting
hook must be engaged in the
mating notch on the upper
carriage bar
Bolt-On Hooks
Quick Change Hooks
Lower
carriage bar
Quick Change
Lower Hook
4
3
Remove plastic
cover
Tab
4
Lower
carriage bar
Inspect
clearance
Lower
carriage
bar
Locking pin
Cascade