Cascade 35D Instrucciones De Montaje página 3

A. Truck Requirements
l
Truck Relief Valve Setting: 160 bar maximum
l
Hydraulic Flow (L/min.) - Clamp Circuit
Min.¨
35D 15
50D 15
70D 45
¨Flow less than minimum could result in umequal
arm movement.
¡Flow greater than maximum can result in excessive
heating, reduced system performance and shortened
hydraulic system life.
l
Hydraulic Flow (L/min.) - Rotate Circuit
Min.¨
35D 19
50D 19
70D 30
¨Flow less than minimum could result in a rotate speed
less than 2 r.p.m.
¡Flow greater than maximum can result in excessive
heating, reduced system performance and shortened
hydraulic system life.
l
Recommended hose and fitting size:
No. 6 with minimum fitting orifices of 7 mm.
No. 8 with minimum fitting orifices of 10 mm.
l
The truck carriage must conform to ISO dimensional
standard 2328, equivalent to dimensions shown.
l
Make sure the truck carriage is clean and the notches
are undamaged.
l
In order to conform to industry standard practice, the
hoses should be connected to the truck auxiliary valve
as shown in the chart.
B. Installation
1 Install a suitable overhead chain hoist. Set the clamp
upright. Remove the bolt-on lower hooks (if equipped).
WARNING: Make sure the overhead hoist
has a rated capacity of at least 1600 kg.
2 Install the Quick Change lower mounting hooks. For
Bolt-On type hooks, proceed to step 3.
Quick Change Hooks
a. Install the guides to the baseplate mounting holes
with the guide holes offset in the upward position -
16 mm from top of guide to the hole center.
Tighten the capscrews to a torque of:
Class 3: 142-155 N.m.
Class 4: 257-270 N.m.
b. Slide the hooks over the top of the guides.
Install each locking pin through the hook lower hole.
Cascade
Recommended Max.¡
26
38
57
Recommended Max.¡
38
38
45
26
38
75
A
45
45
68
Function, in
sequence of
location to
the operator
Rotate
Clamp*
* If solenoid equipped, depress button for CLAMP/
RELEASE functions. Relaese button for ROTATE.
3
Mounting Dimension A - ISO 2328
Minimum
Class 2 380.0 mm
Class 3 474.5 mm
Class 4 595.5 mm
Attachment Motion of the operator's
movement hand, actuating the truck
auxiliary control handle,
facing the load.
Clockwise Rearward or up
Counter Forward or down
clockwise
Clamp Rearward or Up
Release Forward or Down
1
1
2
Guide
Installation Instruction
Maximum
381.0 mm
476.0 mm
597.0 mm
Hook
Pin