LEMAN PON400 Manual De Instrucciones página 70

3. Once the abrasive strip is secured in the left clip, stand in front of the unit and radially
wrap the abrasive material. Roll the drum away from you with your left hand while
holding tension on the abrasive strip with your right hand and guiding the material
onto the drum. Use this technique to warp the abrasive strip edge to edge radilly
around the drum. Make sure you do not overlap the material as you wrap the
abrasive (Figure 14).The material should be flush to slightly gapped, but not
overlapped, during the wrap.
4. When you have completely wrapped the drum, keep tension on the strip and insert
the remaining tapered end of the strip into the slot in the drum. Using your right hand,
raise the tensioner clip completely to open the jaws. Insert the tapered end of the
abrasive strip (Figure 15). The tensioner clip will secure and will secure and tension
the abrasive strip during use and will shold tension in the event the strip stretches
during use. If the abrasive strip is not tightly captured, the tensioner clip was not
Abrasive Cutting Specification
１９
EN
Figure 13
Figure 14
MS3140 DRUM SANDER