Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Inboard
Conveyor
Table
Alignment
Bolts.
Front
NOTE: If the unit is bolted to a stand or bench, loosen the mounting bolts at the
motor end.
2. Using the Height Adjstment Handle Assembly, lower the drum until the distances at A
and B are equal. Tighten the alignment bolts and the mounting bolts.
3. Test sand a piece of wood and check for uniform thickness. Repeat the above
procedure if necessary.
CONVEYOR FEED BELT TRACKING ADJUSTMENT
Occasioal adjustment of the conveyor feed belt tracking may be required due to belt
stretching. ldeally, the conveyor feed belt should track in the center area of the conveyor
feed belt table.
1. Conveyor feed belt tracking adjustment screws are located on both the inboard and
outboard sides on the rear of the wode drum sander. (See Figures 11 and 12.)
１５
EN
Inborard
Conveyor
Table
Alignment
Bolts.
Rear
Figure 10
MS3140 DRUM SANDER
Tabla de contenido
