Advanced Programming - Telcoma Automations TANGO 230 Manual De Uso

GB
STANDARD PROGRAMMING
1. Self-learning
- Shortly press the receiver button corresponding to the channel to be
memorized (fig.1, button P1).
The LED next to the button will blink 5 times.
- While the LED is blinking, press the button on the transmitter corre-
sponding to the code to be memorized.
A longer blink of the LED on the receiver will acknowledge correct memorization.
Repeat the operation to perform self-learning of any other transmitters.
During the programming procedure the distance between the transmit-
ter and the receiver must be about 50cm.

ADVANCED PROGRAMMING

1. Step-by-step output.
- During the programming procedure, press the P2 button twice instead
of once as described in the "Standard programming" section.
- LED2 will emit 5 series of 2 blinks.
- During this stage transmit using a TANGO series transmitter.
- The LED will light up steadily for a few seconds indicating that the lear-
ning procedure has been successfully completed. The output correspon-
ding to the P2 button is now step-by-step.
If there is no power supply and the output was active, it deactivates.
2. Timer output.
- During the programming stage, press the P2 button 3 times.
- LED2 will emit 5 series of 3 blinks.
- During this stage transmit using a TANGO series transmitter.
- The LED2 will light up steadily for a few seconds indicating that the
learning procedure has been successfully completed. The output corre-
sponding to the P2 button is now a timer. The time of the timer is not
26