Fitting The Rear Wheel - NuVinci N360 Manual De Instrucciones

BASIC MAINTENANCE AND CARE

Fitting the Rear Wheel

„ Place the rear wheel into the
rear frame, making sure not to
obstruct shift cables.
Slide one no-turn washer (1)
5
each onto each axle end. The
serrations of the no-turn washer
EN
must bear against the dropout of
the frame. The rectangular boss
must engage in the dropout of the
frame.
„ Mount the axle nuts (2).
Tightening torque 30 – 40 Nm
(266-350 in-lbs).
„ For roller brake applications,
connect the roller brake
according to the manufacturer's
instructions.
Improper installation of the
no-turn washer will result in
damage to the dropout and
the hub.
Over-tightening may damage
parts. Under-tightening can
result in the axle sliding in the
dropouts.
6
Install the shift cable hardware
following steps A, B and C.
„ Check the spring latch to
ensure it is seated properly.
Do not push on the spring
portion of the OD latch (3)
when closing.
4
5
1
1
2
Boss
6
A
B
C
3
BASIC MAINTENANCE AND CARE
Cleaning
„ Your NuVinci N360
components are sealed and
well protected from the external
environment. However, do not
use water under pressure (such
as pressure washers or water
jets) for cleaning to prevent
malfunctions due to water
penetration.
„ During the winter season, you
should clean your bicycle in
shorter intervals so that winter
road salt cannot cause any
damage.
„ Do not use aggressive cleaners.
Lubrication
„ The NuVinci N360 CVP is
provided with permanent
lubrication and the CVP
internals are maintenance-free
for the life of the product.
„ The NuVinci N360 internal
freewheel mechanism is
serviceable.
„ Regular lubrication will extend
the chain's service life.
EN
5