Fitting The Rear Wheel - NuVinci Nfinity Serie Manual Del Propietário

2.5 Fitting the Rear Wheel

1. Place the rear wheel into the rear frame,
making sure not to obstruct shift cables.
2. Slide one no-turn washer (A) each onto
each axle end. The serrations of the no-turn
washer must bear against the dropout
of the frame. The rectangular boss must
engage in the dropout of the frame.
3. Mount the axle nuts (B). Tightening torque
30-40 Nm (266-350 in-lbs).
- For rim and roller brake applications,
connect the rear brake according to the
manufacturer's instructions.
Improper installation of the no-turn

!
washer may result in damage to the
dropout and the hub.
Over-tightening may damage parts.

!
Under-tightening can result in the axle
sliding in the dropouts.
4. Install the shift cable hardware following
1 2 3
steps and
TECHNICAL OWNER MANUAL
1
2
3
Image can differ from product based on product variant
NFINITY OPERATION & CARE
A
B
EN
7