ROBBE Charterte Instrucciones De Montaje página 4

Parts List for the basic wing structure
Part Description
No.
F1a / F1b Bottom centre section sheeting
F  Bottom main spar
F 3 Root rib
F 4 Wing rib
F 5 Wing rib
F 6 Wing rib
F 7 Wing rib
F 8 Wing rib
F 9 Top main spar
F 10 Wing rib
F 11 Riblet
F 1 Riblet
F 13 Riblet
F 14 Trailing edge sheeting
F 15 Aileron recess trailing edge
F 16 Aileron recess doubler
F 17 Aileron recess doubler
F 18 Wing leading edge
F 19 Aileron sheeting
F 0 Aileron rib
F 1 Aileron horn support
F  Aileron horn support
F 3 Aileron leading edge
F 4 Wingtip
F 5 Servo mount
F 6 Servo well cover
F 7 Aileron horn
F 8 Wing dihedral brace
F 9 Centre rib
F 30 Joiner dowel
RC 1 Aileron servo
RC  Servo output arm, one-sided
RC 3 Servo extension lead
Building the model
Stage 1, the basic wing structure
Preparation
- Separate the wing ribs F1 to F13 from the laser-cut
sheets, and clean up the cut edges using abrasive paper.
Assembly and operating instructions
Charterle
Laser-cut
sheet
Sheet A + B
Sheet C
Sheet C
Sheet C
Sheet C
Sheet B, D
Sheet B
Sheet B
Sheet C
Sheet B
Sheet A, B, C
Sheet B
Sheet B
Sheet A
Sheet A
Sheet A
Sheet A
---
Sheet A
Sheet A
Sheet A
Sheet A
Sheet E
Sheet E
Sheet E
Sheet A
Sheet F
Sheet F
Sheet C
---
---
Plastic
---
- Tape the plan down on the building board and cover it
with clear plastic film.
- The instructions describe the construction of one wing
panel; simply repeat the procedure to build the second
panel.
Material, dimensions No. off
Balsa,  mm  each
Poplar, 3 mm  off
Poplar, 3 mm  off
Poplar, 3 mm  off
Poplar, 3 mm  off
Balsa,  mm 4 off
Balsa,  mm  off
Balsa,  mm  off
Poplar, 3 mm  off
Balsa,  mm  off
Balsa,  mm 6 off
Balsa,  mm  off
Balsa,  mm  off
Balsa,  mm  off
Balsa,  mm  off
Balsa,  mm  off
Balsa,  mm  off
Carbon tube, 4 x 400 mm  off
Balsa,  mm  off
Balsa,  mm 10 off
Balsa,  mm  off
Balsa,  mm  off
Balsa, 4 mm  off
Balsa, 4 mm  off
Balsa, 4 mm 4 off
Balsa,  mm  off
Plywood,  mm  off
Plywood,  mm  off
Poplar, 3 mm 1 off
Beech, 4 Ø x 1 mm 1 off
Ready made  off, N.I.
Ready made  off, N.I.
Ready made  off, N.I.
4
- Use cyano glue for all joints unless stated otherwise.
- The two wing panels should not be joined until the aileron
servos have been installed.
No.
3279